Author Archive: Admin

Everything out of the front of your Eagle! Big leads, weld handle, and magnet.

Wiggle Wire Electrode for installing wiggle wire.

This Electronics Upgrade Kit contains timer and all electronics including wires needed to get your dent puller operating at maximum efficiency

Count to 4 for quick troubleshooting your Eagle II ProNumber 1 - Check your power Are you using an extension cord? if so it must be at least as thick as the power cord on your machine. 12 gauge or thicker If you're are using a smaller cord you're starving your machine of power.Number 2 - Electrode Is the tip of your electrode dirty or flat? Your machine cannot make a good weld unless the tip is clean and sharpened like a pencil with just the very end flat. Number 3 - Clean the Panel is the area to be pulled clean of all paint and debris? you must grind your area with fine grit sandpaperNumber 4 - Timer Setting Turn your timer setting to the absolute lowest setting, then turn it up slightly as needed. If the temperate is too high your machine will not weld, and the tip will heat up and flatten.

two extra long electrodes included

Complete assembly

Replacement PryBar Works with all Eagle models.